Understanding Journals Overs and Unders

by Wendy


Most journal printers will apply a notation to their quote specifying their “overs and unders” policy when producing your journal. What exactly does that mean?

And why are “overs” and “unders” necessary?

Each step in a manufacturing process (including the printing process) results in spoilage that must be accounted for in order to ultimately meet a specified print quantity. While this spoilage percentage is somewhat predictable, it is not a fixed quantity but is, instead, a calculated estimate that will result in finished product that falls within a specified range. This allowance for spoilage results in what are known as “overs and unders”—a finished quantity that is over or under the ordered amount.

When a journal printer produces “over” the specified quantity (but within the specified range), the publisher has the option of accepting those copies or not, but they will be billed for those copies in either case. On longer runs (web work), “over” tolerances typically run anywhere between 1% and 3%, depending on the complexity and run length of the project. On shorter run (sheetfed work), the “over” tolerance is likely to run higher, often up to 5%, due to manufacturing differences. Publishers should not rely upon “overs” to meet their print order requirements, as “over” quantities may vary from issue to issue. (Note: “Overs” should not to be confused with “overruns”. Overruns occur when a publisher requests one or more signatures to be overrun beyond the base quantity. Overruns are typically used as stand-alone products.)

“Unders” occur when the journal printer falls short of the quantity ordered. A printer who quotes “2% under and 5% over” on an order of 4,000 copies, could deliver 3,920 copies and call the order complete. They could also charge for an additional 200 copies if they ran the full 5% over. Some printers will only quote an “over” number in which case, if the printer runs short, or “under”, they will contact the publisher and offer to go back on press if the balance is required.

“Overs and unders” represent the variables inherent in the manufacturing process, and while they may vary from job to job or printer to printer, both are a normal part of the journal printing process.

At Sheridan, we appreciate that you are in print!